Question by Shanda M: What should I do about this used car I bought, involving the lemon law? 1. purchased 2002 Jetta $ 14,000 on 3/27 2. Received on 3/30/07 (due to maintenance and inspection) 3. 3/31-noticed leak (believe transmittion) and ball bearings off (hear and feel) 4. 4/3- called for servicing (can’t get in [...]
Archive of posts tagged used
Q&A: What type of bearing is used to support the connecting rod on the crank pin and the wrist pin in high rpm two-?
Question by Engle: What type of bearing is used to support the connecting rod on the crank pin and the wrist pin in high rpm two-? 3. What type of bearing is used to support the connecting rod on the crank pin and the wrist pin in high rpm two-stroke engines? A. Roller bearing B. [...]
I Used the Gear Puller without unhooking the Tie Rod and Lower Arm Ball Joint?
Question by maguyver727: I Used the Gear Puller without unhooking the Tie Rod and Lower Arm Ball Joint? on a 97 Ford Contour—was going to Change the Wheel Bearing on passenger side. Pushed the Axle in about 3/4 of an inch. Will this hurt the inner seal for the Axle? Will it hurt anything inside [...]
